From: Hendrik van Eeden <hvaneeden-AT-comcast.net>
Date: 24 Jun 2009 06:56:18 UTC   (09:56:18 AM in author's locale)
To: xtensionlist-AT-shed.com

Ard,

How did you get the firmware update? I looked all over the RFXCom site and could not locate it.


Henk


On Jun 24, 2009, at 9:21 AM, ard jonker wrote:

> Since the firmware upgrade yesterday by RFXCom, the oregon sensors > work like a charm. Repeatedly pressing the 'reset' button helped to > get me an address in the P (peculiar?) range for all three sensors.
>
> Now I notice that although they show °C on the front panel, XTension > insists on displaying the °F reading. Is there an obvious way (lest > conversion calculation) of switching to °C?
>
> Another question, related, is changing the label in the Master List. > I noticed that I could set the 'ON' label to 'warm' for a furnace. > Wouldn't it be nice to have the temperature shown in the 'Value' > column of the master list? E.G. have the last temperature reading > (25°C) set as 'ON' label.
>
> For that, I need to change the 'On' label for Unit type by > Applescript. All 'label' references that I found in the manual > (verbs, that is) refer to 'Views'. I don't have a view, I only use > the Master List.
>
> Ard
> _______________________________________________
> XTensionlist mailing list
> XTensionlist-AT-shed.com
> lists.shed.com/mailman/listinfo/xtensionlist

_______________________________________________
XTensionlist mailing list
XTensionlist-AT-shed.com
lists.shed.com/mailman/listinfo/xtensionlist